Publicidad
Adjusting the Angle
This installation hardware allows the display to be directed downwards freely at any angle from the vertical to 25°.
This adjustment must always be done by 2 people.
Adjust the angle by rotating the screws at the center top and center bottom of the wall side hardware to the left or right.
Note
If the angle is increased while you are adjusting the angle using the screw at the center of the bottom, it is difficult to turn the
screw. When this happens, adjust it at the center of the upper.
Turn the screws very carefully to avoid damaging the wall.
When a screw becomes tight at either end of the adjustment range, do not turn the adjustment screw any further, because if
you do, you will apply excessive force, deforming the screw.
A When vertical (side view)
Overlapped
Resin
plate
When it is in this state, do not turn
the adjustment screw any further in
the closing direction.
Closing
A
Resin plate
Specifications
External dimensions
Weight
• The above specifications and exterior may be modified without prior notice to improve the product.
12
En
PDP side
hardware
(Surface where
the spacer is
attached)
When it is in this state, do not turn the
adjustment screw any further in the
opening direction.
Hexagon wrench
Opening
740 (W) x 573 (H) x 67 (D) mm (29-1/8 (W) x 22-9/16 (H) x 2-5/8 (D) inch)
13.8 kg (30.4 lbs)
B When inclined at 25°
End face of the plate
Matched in both
directions
Notch
Tilt Angle Criteria
Angle
Standard holes of
50-inch model
5°
192 (7-9/16)
10°
246 (9-11/16)
15°
298 (11-23/32)
B
20°
348 (13-11/16)
Angle of incline and appearance of the screw for angle adjustment
from a horizontal position on the front
PDP-506XDE
PDP-506FDE
PDP-506HDG
PDP-436XDE
PDP-436FDE
PDP-436HDG
One body type
plasma display
Measuring the opening distance X
enables approximate angle values to
be determined.
X
X
Standard holes of
Upper holes of
43-inch model
43-inch model
188 (7-13/32)
191 (7-17/32)
238 (9-3/8)
244 (9-19/32)
287 (11-5/16)
296 (11-21/32)
334 (13-5/23)
346 (13-5/8)
Standard hole
23° or more
visible
to 25°
16° or more
visible
22° or more
15° or more
visible
21° or more
Unit: mm (inch)
One body type
standard hole
212 (8-11/32)
262 (10-5/16)
310 (12-7/32)
357 (14-1/16)
Upper hole
invisible
visible
visible
Publicidad
