Culligan WH-S100-0 Instrucciones De Instalación página 5

INSTALLATION
• Install filter after water meter or pressure tank.
• Only Teflon tape is recommended for fitting connections.
®
• Note differences between WH-S100-O and WH-S200-C.
• Instructions are for installing 3/4˝ compression fittings (separate fittings required for other sizes
and non-copper pipe).
1
A
Turn off water supply (A) and open nearest
faucet to drain pipes before installation.
Apply about 6˝ of Teflon
direction to pipe threads of each adapter.
IMPORTANT: When choosing location allow
1-1/2˝– 2˝ clearance below housing to allow
for filter changes.
2 WH-S200-C
If using optional BR-C mounting bracket, start by
making sure the arrows facing you on the system
are consistent with the direction of your water
flow. If necessary, remove filter life indicator
holder if on the back side of the unit, and move
it to the front. Align the holes of the bracket with
the holes on the back of the filter head. Insert four
mounting screws through the bracket and into the
filter head until tight. Otherwise skip to step 3.
B
tape (B) in clockwise
®
2 WH-S100-O
If using optional BR-O mounting bracket (sold
separately), start by making sure the arrows
facing you on the system are consistent with the
direction of your water flow. Remove head cap
and align the holes in the bracket with the holes
in the filter head. Insert four mounting screws
through the bracket and into the filter head until
tight. Replace head cap. Otherwise skip to step 3.
3
Assemble all fittings. Start adapters (not
included) into filter head by hand. Use a wrench
to tighten firmly.
DO NOT OVER-TIGHTEN.
5