Whispbar K427W Instrucciones De Montaje página 7

EN
Fitting Kit
K427W
Fitment
Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
Please check the rear of this manual for
information relating specifically to your
vehicle.
NOTE: FRONT CROSSBAR ONLY
Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
To install the front crossbar, pull back top
rubber door seal. Locate threaded inserts
under black spots above the front doors.
Put front clamp in place. Refit the clamp
block over clamp. Refit locking screw,
ensuring end of screw inserts in the hole on
the clamp.
7