Air Inlet - Cola BEAUTY Serie Manual De Instalación, Uso Y Mantenimiento

Packing is placed inside the lid of the stove packed accordingly: Carefully open the package, check the integrity of
the piece and at the end of the placement of the stove to install it as follows:
X-mount the top cover by aligning the 4 locations with 4 dampers set on the stove.
Y-lock the lid in place to secure the bracket in the tank as shown
X
Y

2.3 Air inlet

The stove air inlet pipe or intake is located at the back and is round and 50 mm in diameter.
A quantity of air at least equal to that necessary for combustion must flow in the room where the stove is installed;
therefore the combustion air necessary to ensure correct operation of the stove must be drawn:
from the room, provided there is a wall air inlet near the stove, communicating with the outside and of minimum
►
area 100 cm² suitably protected externally by a grille;
or with direct connection to the outside with an appropriate pipe having a minimum internal diameter of 50 mm
►
and maximum length of 1.5 m, provided with antiwind protection at the end (down bend).
The air inflow can also be obtained from a room adjoining that of installation, provided the flow can occur freely
through permanent openings to the outside; the room must not be used as a garage, for storing combustible
materials or for activities with fire risk.
STOP
BRACKET
COVER
46 BEAUTY ** - BEAUTY LUX **