Problem
A rectangular symbol is
shown instead of numbers
on the Temperature Dis‐
play.
The lamp does not work.
The compressor operates
continually.
Water flows on the rear
plate of the refrigerator.
Water flows inside the
wine cellar.
DEMO appears on the dis‐
play.
The temperature in the
wine cellar is too low/too
high.
Possible cause
The door is left open.
The temperature in the
appliance is too high.
Temperature sensor
problem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many products were put
in at the same time.
The room temperature is
too high.
Products placed in the
appliance were too
warm.
The door is not closed
correctly.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Products prevent that
water flows into the water
collector.
The appliance is in dem‐
onstration mode.
The temperature regula‐
tor is not set correctly.
ENGLISH
Solution
Close the door.
Contact a qualified electri‐
cian or contact the nearest
Authorized Service Centre.
Contact the nearest Author‐
ized Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Close and open the door.
Refer to "Replacing the
lamp".
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow products to cool to
room temperature before
storing.
Refer to "Closing the door".
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Keep the Light button press‐
ed for approximately 10 sec‐
onds until a long sound is
heard and display shuts off
for a short time.
Set a higher/lower tempera‐
ture.
11