Mounting The Cisco 350 Series Switches; Rack Mounting - Cisco 350 Serie Guia De Inicio Rapido

– Diameter of the screw head: 6.8 mm
– Length of face of screw head to base of screw: 16 mm
– Shaft diameter: 3.5 x 1.3 mm
• Computer with Microsoft Internet Explorer (version 9.0, 10.0, 11.0),
Mozilla Firefox (version 51.0, 52.0, 53.0, or higher), or Google Chrome
(version 56, 57, 58, or higher) for using the web-based interface or the
console port to manage your switch.

Mounting the Cisco 350 Series Switches

2
Depending on your switch, there are two or three ways to install the switch:
• Place the switch on a flat surface. To place the switch on a desktop,
install the four rubber feet (included) on the bottom of the switch.
• Mount the switch in a standard rack (1 rack unit high).
• Many of the 350 Series Cisco switches include wall-mounting slots on
the bottom of the device.
Placement Tips
Do not deploy the switch in a location where any of the following
conditions exist:
• Ambient Temperature—To prevent the switch from overheating, do not
operate it in an area that exceeds an ambient temperature of 122°F
(50°C).
• Air Flow—Be sure that there is adequate air flow around the switch.
• Mechanical Loading—Be sure that the switch is level and stable to
avoid any hazardous conditions.
• Circuit Overloading—Adding the switch to the power outlet must not
overload that circuit.

Rack Mounting

You can mount the switches in any standard size, 19-inch (about 48 cm)
wide rack. The switch requires 1 rack unit (RU) of space, which is 1.75
inches (44.45 mm) high.
For stability, load the rack from the bottom to the top, with the
C
AUTION
heaviest devices on the bottom. A top-heavy rack is likely to
be unstable and might tip over.
Cisco 350 Series Managed Switches 3