Assembly And Pre-Operation; Trigger Safety Latch - Campbell Hausfeld CP5580 Manual De Instrucciones Y Lista De Piezas

Operating Instructions and Parts Manual

Assembly and Pre-Operation

ASSEMBLY AND PRE-OPERATION
1. Attach the lance to the gun (See
Figure 8).
2. Install quick connect tip (See
Figure 9).

TRIGGER SAFETY LATCH

In the engaged position, the trigger
safety latch prevents the gun from being
triggered accidentally. Push the latch fully
up to engage it (See Figure 10 and 11).
Always engage the trigger safety latch
when the unit is not in use.
BATTERY SET-UP AND CONNECTIONS
This unit DOES NOT come with a battery
or battery cables. A 12 Volt battery must
be connected to the unit. The 12 Volt
battery must be at least a U group size
number. Using at least 8 AWG battery
cables, a connection must be made from
the starter solenoid on the Honda engine
to an in-line 30 amp fuse, and then to the
positive terminal of the 12 Volt battery.
From the negative battery terminal, a
connection must be made to the ground
screw located on the left side of the frame.
Please refer to the wiring schematics in
this manual. If you have any questions,
please contact customer service at
1-800-746-5641.
10
www.campbellhausfeld.com
Figure 8 - Attach lance to gun
Figure 10 - Trigger locked
Figure 9 - Quick connect tip
Figure 11 - Trigger unlocked