LUBRICATION
no lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
STORAGE
Before storing your vacuum cleaner the tank should be emptied and cleaned.
The power cord can be wrapped around the cord wraps provided on the tank
cover on rear of unit (figure 19). The vacuum should be stored indoors.
TROUBLESHOOTING
Trouble
Possible Cause
Suction weakens or
Clogged filter
cleaner runs hot
Air leak
Obstruction in hose
or nozzle
Misting in the
Saturated filter
exhaust air
WARNING
SHOULD BECOME DETACHED OR BROkEN, EXPOSING THE MOTOR OR ANy
OTHER ELECTRICAL COMPONENTS, OPERATION SHOULD BE DISCONTINUED
IMMEDIATELy TO AVOID PERSONAL INjURy OR fURTHER DAMAGE TO THE
VACUUM. REPAIRS SHOULD BE MADE BEfORE REUSING THE VACUUM.
TWO yEAR HOME USE WARRANTy
your Shop-Vac® vacuum cleaner is warranted for normal household use, in accordance with
the user Manual, against original defects in material and workmanship for a period of two years
from date of purchase. Should this product be used for commercial or rental use, a 90 day lim-
ited warranty will apply. Shop-Vac Corporation warrants placing this vacuum cleaner in correct
operating condition, by repair or parts replacement, during the warranty period, without charge.
This warranty does not cover accessories. use of non-recommended filters and/or accessories
may void the manufacturer's warranty. Shop-Vac® assumes no responsibility for damage or
faulty performance caused by misuse, careless handling, and where repairs or modifications
have been made. do not attempt to service your vacuum beyond that described in the user
Manual. Proof of purchase date is required. The warranty gives you specific legal rights, and
you may have other rights which vary from state to state or province to province. This warranty
is void outside of the united States and Canada.
Customers in the united States: for product service contact Shop-Vac Corporation, Customer
Service, at (570) 326-3557 or go to www.shopvac.com/support. Visit www.shopvac.com for
your vacuum's parts list schematic.
Remedy
Brush dirt from filter. If condition continues,
change filter.
Check all fittings for tight fit (nozzles, hose, etc.)
Check that tank cover is sealed properly.
Check nozzle, hose, etc. for obstructions, and
remove if present.
Replace saturated filter with a dry filter.
– If ANy Of THE MOTOR HOUSING PARTS
19