Removing The Packaging; Installation Preparation - Gaggenau RB 491 Instrucciones De Instalación


Move the appliance with a hand truck securely.
3.

Removing the packaging

m
WARNING
– The appliance may tip over while it is being
unpacked.
– The appliance is very heavy.
– When opening the appliance door, the appliance
may tip forwards.
Be careful, otherwise people who are helping may be
injured or the appliance may be damaged
To protect the base from damage during installation:

Attach a residual piece of carpet, lino, etc. to the floor
with adhesive tape in front of the intended installation
location.

Remove transportation packaging:
Remove the cartoon. Use the cutter securely to protect
the surface of appliance.
Remove packaging material.
Attach the power cord to the back of the appliance with
a piece of adhesive tape.
Remove transportation protection devices and lift
appliance off the pallet – appliance is very heavy!
Remove accessories from the outside of the appliance.
16
Keep adhesive tape which was used to attach
the supplied accessories to the appliance.
It is used subsequently for attaching the edge
protection to the cavity walls (see Section 9.).
Carefully open the appliance – risk of tipping over – and
remove accessories and installation materials from
inside the appliance. Close the door again.
m
Do not remove transportation safety devices which
protect the shelves and storage compartments
inside the appliance until the installation is
complete, otherwise the parts may be damaged.

Check appliance for damage in transit.
Do not install the appliance if it is visibly damaged.
If in doubt, contact your dealer.
4.

Installation preparation

m
Unpack installation materials and accessories.
To improve allocation to the work steps, the packages are
identified differently.
To do this, comply with the overview sheet attached to the
appliance!
CAUTION
m