AEG RCB83326MX Manual De Instrucciones página 13

Problem
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Side panels of the appli-
ance are warm.
There is too much con-
densed water on the rear
wall of the refrigerator.
Door does not open easily.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
7.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Possible cause
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The food products temper-
ature is too high.
Many food products were
stored at the same time.
The FROSTMATIC function
is switched on.
The COOLMATIC function
is switched on.
This is a normal state
caused by operation of the
heat exchanger.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrap-
ped.
You attempted to re-open
the door immediately after
closing.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
ENGLISH
Solution
Keep the mode key pressed
for approximately 10 seconds
until a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Refer to "FROSTMATIC func-
tion".
Refer to "COOLMATIC func-
tion".
Make sure that there is at least
30 mm of space between each
side of the appliance and the
surrounding furniture when
the ambient temperature ex-
ceeds 38°C.
Open the door only when nec-
essary.
Make sure the door is closed
completely.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Wait a few seconds between
closing and re-opening of the
door.
13