Franke Maris 90 Manual De Uso página 11

4. CONTROLS
L
Button Function
L Turns the lights ON/OFF at maximum strength.
T1 Turns the motor on/off at speed one.
Delay Function:
Press and hold the button for approx. 3 seconds to Activate/Deactivate the
Delay function (automatic switching off of the Motor, the Fans and the Lighting
with a 30' delay).
Cannot be enabled when Intensive or 24H are on.
T2
Turns the Motor on at speed two.
Press and hold the button for approximately 5 seconds, with all the loads
turned off (Motor and Lights), to turn the Activated Charcoal Filter alarm on.
The relevant LED flashes twice to confirm.
To turn the alarm off, press the button again and hold for at least 5 seconds.
The relevant LED flashes once.
T3
Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads
turned off (Motor and Lights), to reset the Filter saturation alarm. The
LED S1 flashes three times.
T4 Turns the Motor on at INTENSIVE.
This speed is timed to run for 6 minutes. At the end of this time, the
system returns automatically to the speed that was set before. If it is
activated with the motor turned off, the hood will switch to OFF at the
end of the time.
Press and hold for 5 seconds to enable the remote control, indicated by
the LED flashing twice.
Press and hold for 5 seconds to disable the remote control, indicated by
the LED flashing just once.
S1 Signals the Metal Grease Filter saturation alarm, indicating that it is
necessary to wash the filters. The alarm is triggered after the Hood has
been in operation for 100 working hours.
Signals the Activated Charcoal Filter saturation alarm. The filter must be
changed after the Hood has been working for 200 hours.
T1 T2 T3 T4
S1
Led
-
-
Flashing
-
Flashing
-
Flashing
-
Flashing
Fixed
Flashing
11