Sharp XE-A42S Manual De Instrucciones página 10

3
Preparing the cash register
To make the cash register ready for operation, remove the
retainer and set the print head release lever in print position.
1.
Push the printer cover forward and detach it.
2.
Remove the white retainer at the position shown at the right. Please
keep this retainer for future use when transferring the cash register.
3.
Move the print head release lever to the printing position as
illustrated at the right.
4
Installing paper rolls
Precaution: The paper cutter is mounted on the printer (receipt side). Take caution when
The register can print receipts and journals. For the printer, you must install the paper rolls (receipt and journal
paper rolls) provided with the register.
Install the paper rolls according to the procedure shown below with the power cord connected and the mode
switch set to the PGM position:
How to cut a paper roll and set it in the paper roll cradle:
Correct
When setting a new paper roll in the paper roll cradle, be sure to cut the paper end behind the
taped (or pasted) point in advance.
1.
Cut off approximately one revolution of each paper roll. Make sure each paper end is cut as illustrated
above.
2.
Set a paper roll in the paper roll cradle of the receipt side as illustrated
above.
3.
Insert the end of the paper roll into the paper chute until it is caught by
the printer auto-feed and comes out of the top of the printer. If the
printer does not catch the paper, feed the paper while pressing the
key.
4.
Cut off excess paper with the paper cutter.
8
installing paper rolls.
Incorrect
To the printer
Correct
{
Retainer
Print head
release lever
(printing position)
To the printer
Incorrect