Setup; Adjusting Storage Shelf Dividers; Door Locks - Tripp-Lite CSC32USBWHG Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Setup

Caution! Read All Instructions and Warnings Before Installation!
Warning: Charging stations can be extremely heavy. Do not attempt to unpack the charging station without assistance. Follow
the unpacking instructions document that shipped with this product before proceeding with setup. Use extreme caution when
handling the charging station and be sure to follow all handling and installation instructions. Do not attempt to install
equipment without first stabilizing the charging station.
4.1 Installing the Handle Bracket and Power Cord Manager
To install the handle bracket, use the included hex key tool to attach four (4) hex screws to the charging station cabinet
manager, use the same hex key tool to secure the eight (8) hex screws that attach the cord manager brackets (four per bracket) to the charging
station cabinet
.
B
A

4.2 Adjusting Storage Shelf Dividers

Your charging station comes with two storage shelves with adjustable dividers that can
each accommodate up to 16 personal electronic devices.
Remove any personal electronic devices stored on the shelf tray. Then remove the
blanking panel. To remove the shelf tray from the cabinet, push the shelf tray forward
to disengage from the mounting hook, then pull the tray up and out. Once the shelf is
removed, remove or rearrange a spring-wire divider by first pulling it gently forward to
disengage it from the rear end
as necessary for additional shelf dividers.
4.3 Powering the USB Charger/Hub Unit
With the bottom blanking panel removed, find the USB Charger/Hub unit's input plug and cable
located in the charging station's bottom compartment, then push the input plug through one of the
cable access hole grommets located on either side of the charging station cabinet (using the cable
access hole on the same side as the power cord manager is recommended). Plug the power cord
into the nearest 3-prong, grounded wall outlet and reattach the blanking panel to the unit.

4.4 Door Locks

The split doors contain a lock that is accessible with the included keys.
A
, then pull it up from the front of the tray
B
B
. Repeat
4
. To install the cord
A
A
B

Publicidad

Tabla de contenido
loading

Tabla de contenido