INVENTOR EVP-WF16L Manual De Usuario página 25

The unit does not start
Make sure the dehumidifier's plug is placed completely into the socket.
l
Check the house fuse/circuit breaker box.
l
Check whether the power cord is damaged.
l
Check the water bucket, if it is full, empty it.
l
Check if the dehumidifier has reached its preset level.
l
Make sure the water bucket is positioned properly.
l
Room temperature is lower or higher than the advised operational range.
l
Check whether the humidity level has been set in high levels.
l
Dehumidifier does not dry the air as efficient
Make sure that the dehumidifier has been operating enough time to remove the moisture.
l
Make sure there are no curtains, blinds or furniture blocking the front or back of the
l
dehumidifier.
The humidity selector may not be set low enough.
l
Make sure you have cleaned the filter as suggested. Clogged filter may result in reduced
l
performance.
All house exits (windows doors etc) where the dehumidifier is operating, should be shut.
l
Room temperature is below the advised operational range.
l
There is a kerosene heater or something giving off water vapor in the room.
l
The room that the device is placed is bigger than suggested.
l
The humidity level is too high.
l
The unit makes a loud noise when operating
The air filter is clogged.
l
The device is tilted instead of being in an upright position.
l
The floor surface is not flat.
l
Frost build up on coils
This is normal. This unit is supplied with an Auto defrost feature.
l
Drain hose water leakage
Check the correct installation of the drain hose.
l
Check for any blockage or damage of the drain hose.
l
Understanding Error and Protection codes
Error Codes:
AS- Humidity sensor error-- Power off unit and temporarily unplug allowing device to reset. If
error persists, call for service.
ES- Temperature sensor error-- Power off unit and temporarily unplug allowing device to reset.
If error persists, call for service.
E3 - Unit malfunction-- Power off unit and temporarily unplug allowing device to reset. If error
persists, call for service.
EC- Refrigerant leakage detection— Unit auto detects refrigerant leakage, if this occurs the EC
EN
25