Troubleshooting - HoMedics THERA P BPA-200 Manual Del Usuario

TROUBLESHOOTING

If any abnormality arises during use, please check the following points
SYMPTOMS
Unit does not turn on when
the START/STOP
button is pushed.
EE measurement error
symbol shown on display or
the blood pressure value is
displayed excessively low
(or high).
Er error symbol shown on
display - measurement
result exceeds
measurement range.
E1 error symbol shown on
display
E2 error symbol shown on
display
E3 error symbol shown on
display
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble or
attempt to repair the unit by yourself. Contact information for
HoMedics Consumer Relations Department can be found on
the warranty page.
POSSIBLE
CAUSES
Batteries have
run down.
Battery polarities
have been positioned
incorrectly.
Cuff has been placed
incorrectly.
Did you talk or move
during measurement?
Shaking of the arm with the
cuff on.
Did you move during
measurement?
Shaking of the arm with
the cuff on.
Air circuit abnormality. Cuff
tube may not be plugged
into monitor correctly.
Inflation pressure exceeding
300 mmHg.
Data error.
28
CORRECTION
Replace them with
four new AA
alkaline batteries.
Re-insert the batteries in the
correct positions.
Wrap the cuff properly so
that it is positioned
correctly.
Measure again. Keep arm
steady during
measurement.
Measure again. Do not
move during measurement.
Check cuff connection.
Measure again.
Switch the unit off, then
measure again.
Remove and reload the
batteries.