Switching On And Off; Standby Mode; Dioptre Adjustment; Info Bar - Liemke CHALLENGER-35 Manual De Instrucciones

Before use
A technical inspection of the device is recommended before use.
> Check the external appearance of the device: There should be
no cracks in the casing.
> Check the condition of the lens and eyepiece: There should be
no cracks, greasy spots, dirt or other deposits.
> Check the condition of the battery: It should be charged if
necessary.
> Check all electrical contacts: There must be no salts or oxidised
spots.

06. SWITCHING ON AND OFF

> Switch on the unit by pressing and holding the Power button.
The start screen appears and after a few seconds the image is
displayed.
> Switch off the unit by pressing and holding the Power button.

07. STANDBY MODE

To increase the battery life, the unit can be set to standby mode.
> When the unit is switched on, briefly press the Power button to
enter standby mode.
The unit goes into standby mode.
> Briefly press the Power button again to wake the unit from
standby mode.
The unit wakes up immediately; there is no waiting time as is the
case when the unit is switched on after it has been switched off
completely.

08. DIOPTRE ADJUSTMENT

The dioptre adjustment adjusts the eyepiece of the unit to the
individual vision of the user.
> Close the lens cover and turn the dioptre adjustment wheel
clockwise or anticlockwise until you can see the symbols in the
display clearly.

09. INFO BAR

The info bar in the upper right corner
of the picture shows the digital zoom
setting, the memory capacity (no bar = empty) and the charge
level of the built-in battery (three bars = full). If WiFi is activated, the
WiFi symbol from the menu is also displayed in the info bar.