Troubleshooting Tips - GE PT9800 Manual Del Propietário

Troubleshooting tips ... Before you call for service
Save time and money! Review the charts on the following pages first and you may not need to call for service.
Problem
LIGHTS
Light during a speedcook
cycle dims and cycles on
and off, even at full power
levels
Light visible around the
door and outer case while
speedcooking
FAN
Fan continues to run after
cooking stops
Oven vent emits warm air
while oven is on
Fan comes on
automatically when using
the microwave
COOKING
The oven makes unusual
sounds while cooking
Smoke comes out of the
oven when I open the
door
Food is not fully cooked
or browned at the end of
a cooking program
SENSOR ERROR
displayed along with an
oven signal
DISPLAY
The display is blank
"Control is LOCKED"
appears in display
49-80741-2
Possible Cause
This is normal. Power level has
been automatically reduced
because the oven is hot.
This is normal.
The oven is cooling.
This is normal.
This is normal.
Clicks and fans blowing are normal.
The relay board is turning the
components on and off.
Food is high in fat content. Aerosol
spray used on the pans.
Programmed times may not match
cooking.
Food amount or type placed in the
oven does not match the program
that was set.
Steam was not sensed by the oven
because plastic wrap was not
vented, a lid too tight was on the
dish or a liquid was covered.
Power saver mode may be
activated.
A fuse in your home may be blown or
the circuit breaker tripped.
Power outage or surge
The control has been locked.
What To Do
adjusts automatically.
door and outer case.
parts of the oven have cooled.
lower lamps for browning and doneness.
Press the Clear/Off
match the food or liquid to be cooked or heated.
when cooking or heating.
Settings menu for clock display settings.
reset it by pressing the Clear/Off pad, setting the
clock and resetting any cooking function.
Press and hold Settings pad for 3 seconds to unlock
the control.
33