Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MODEL WS-30 INSTALLATION
Panel Installation
DOOR PANEL
To install the custom door panel, remove the handle side
trim molding. Insert a screwdriver tip into the top corner slot
on the handle side and pop out the trim. Remove the screws
and frame. Refer to the illustration below.
1
The door has a
/
"
frame for the custom panel to slide
(6)
4
into. If the panel is thicker than a
around the panel or mount the panel on a sheet of
thick material, then insert into the frame.
Door side trim.
|
26
Sub-Zero Customer Care 800.222.7820
1
/
"
, rout an edge
(6)
4
1
/
"
(6)
4
A .10"
space is required between the backer panel and
(3)
the custom panel to allow the panel to slide into the door
frame. Refer to the illustrations below for critical dimensions.
Install handle hardware before inserting the panel. Large
D-style handles are recommend rather than knobs. Screw
heads must be countersunk into the panel.
Slide the panel into the frame.
To reinstall the door trim molding, insert the top of the trim
into grooves at the top of the door and work downward,
snapping the trim into clips on the door frame.
SPACER PANEL
CUSTOM PANEL
BACKER PANEL
TRIM
5
/
"
16
(8) min
1
/
"
8
(3) (OVERLAY)
Panel assembly cross section
(overlay).
CUSTOM
SPACER
PANEL
PANEL
BACKER
PANEL
3
/
"
4
1
(19)
.10"
/
"
(3)
4
(6)
typical
Panel assembly rear view.
Publicidad
Tabla de contenido
