Sanding Assembly - Bosch GWX18V-50PC Instrucciones De Funcionamiento

▶ Sanding Assembly

tool operations. Do not discard guard
when not in use. Always reinstall wheel
guard when converting back to grinding
operations.
of the accessory X-Lock Mounting Hub
surface is not above the top of the Clamp-
ing Height Gage. Accessories that are
above the clamping height gage may not
be fixed properly and separate from the
the tool causing personal injury and/or
property damage.
The Hand Shield is to be used with back-
ing pads, sanding discs and wire brushes
to keep fingers and hand away from work
surface, sharp edges, burs and debris.
When using the Hand Shield accessory, in-
sert side handle through hole in shield and
then thread into housing (Fig. 4). Ensure
that hand shield is positioned between
hand and backing pad, sanding disc or
wire brush.
▼ To install backing pad and sanding
disc (Fig. 13)
1. Inspect Hand Shield to ensure that it is
properly attached to the grinder.
2. Place the Backing Pad onto the X-Lock
Accessory Mount with the rectangular
openings positioned around the X-Lock
Clamping Tabs.
3. Center the Sanding Disc on top of the
Backing Pad and align the rectangular
cut-outs with the Clamping Tabs on the
X-Lock Accessory Mount.
160992A4FH 05-19 GWX18V-50PC.indd 19
page heading Assembly
A type 27 wheel guard
may not be used for all
Confirm proper clamp-
ing by ensuring that top
Fig. 13
X-Lock
Clip
Sanding
Disc
Backing
Pad
Hand
Shield
4. Align the X-Lock Clip with the slots in
the Sanding Disc. Insert the X-Lock
Clip through the Sanding Disc and ap-
ply pressure to it, until it is fully en-
gaged by the Clamping Tabs, which will
be indicated by an audible "click".
5. To remove the sanding assembly from
the grinder, follow instructions for
Mounting and Removing X-Lock Acces-
sories starting on page 15.
-19-
Clamping
Tabs
6/3/19 7:29 AM