Makita DPV300 Manual De Instrucciones página 4

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Maximum capacities
Backing pad diameter
Rated speed (n) /
No load speed (n )
0
Overall length
Rated voltage
Net weight
*1. With battery cartridge (BL1860B).
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for polishing, smoothing before
painting, finishing surfaces, and removing rust and
paint.
Noise
The typical A-weighted noise level determined accord-
ing to EN60745-2-3:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Wool pad
Sponge pad
Sanding disc
For sanding
For polishing
High (2 ):
sanding mode
Low (1 ):
polishing mode
) : 73 dB(A)
pA
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the tool is
used especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (tak-
ing account of all parts of the operating cycle such
as the times when the tool is switched off and when
it is running idle in addition to the trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745-2-3:
Work mode: disc sanding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode: polishing
Vibration emission (a
Uncertainty (K) : 1.5 m/s
4 ENGLISH
DPV300
80 mm
80 mm
50 mm
46 mm
75 mm
-1
0 - 9,500 min
-1
0 - 2,800 min
160 mm *1
D.C. 18 V
1.3 - 1.6 kg
DC18SH
2
) : 2.5 m/s or less
h, DS
2
2
) : 2.5 m/s or less
h, P
2