Cleaning And Care - brennenstuhl WV 4/16A IP44 Manual De Instrucciones

089417 BA_Wandverteiler WV 4_16 4_32.qxp 07.02.18 15:31 Seite 16
Operation
– To connect a load, open the hinged lid of the socket and insert the plug of the load completely.
– To remove a load, switch off the connected load first, then lift the hinged lid of the socket slightly
and pull the plug out of the socket.
WARNING
Improper use may damage the device and lead to injuries.
– Always use the plug housing to pull a connected device plug out of the socket.
– Do not pull the plug using the cable.
– Ensure that the cables are not kinked, crushed or run over or come into contact with external heat
sources.
Maintenance
Regular maintenance work increase the service life and support the failure-free and safe operation of
the device. In this way, possible faults are detected early and hazards are prevented.
Check unit for damage
– Check the device for external damage in a visual inspection
(e. g. missing parts, material changes, cracks, etc.).
– Check the hinged lids of the sockets and windows for proper function.
– Have a qualified electrician replace any damaged hinged lids or windows.
– If you notice any damage at the device, immediately contact a qualified electrician.
– Do not continue to operate the faulty device since the risk of electric shock or damage to property
(e. g. due to a fire) may be increased.
– If required, have the device properly repaired or decommissioned by a qualified electrician.
Check the residual current device
The functionality of the residual current device (RCD), fig. A (5) must be checked regularly. The test is
performed by operating a test button which triggers the residual current device.
– Bring the switch lever in the "I-ON" position.
– Press the test "T" button. → The residual current device is triggered, the switch lever moves to the
"O-OFF" position.
– If any malfunction occurs during the test procedure or if the residual current device is not triggered,
the distribution box must be decommissioned and a qualified electrician must be informed.

Cleaning and care

The device can be cleaned using a dry or damp cloth depending on the conditions of use and the
amount of dirt.
To prevent persistent dirt, we recommend regular cleaning with a dry cloth.
Before starting cleaning work, remove all connected loads from the device (see "operation" section).
DANGER
Working at live parts may cause severe or fatal injuries.
– For wet cleaning, the device must be de-energized.
– Only clean the outside of the device and the parts (e. g. sockets).
– Do not open the device and keep the sockets closed.
– Never use steam cleaners or high-pressure cleaners.
– Unsuitable cleaning agents, cleaning equipment and excessive water may damage the device.
16
WV 4/16A IP44 · WV 4/32A IP44