Greencut GTC300X Manual De Instrucciones página 78

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

78
TILLER CONTROLS
(1) Accelerator
(2) Clutch activation
(3) Selector switch
(4) Horizontal adjustment handlebar
(5) ON/OFF Switch
ACCELERATOR (1)
-
Left: minimum number of engine revolutions.
-
Right: maximum number of engine revolutions.
CLUTCH OPERATION (2)
Press the clutch drive to transfer the movement of the engine to the gearbox, remember to reduce the engine speed
before activating the clutch.
The clutch activation acts as a safety device during the use of the tool on reverse gear, do not use your tiller if this
device is damaged and/or does not operate correctly.
GEAR SELECTOR (3)
Method of use:
a) a) Using the accelerator, lower the engine speed until it is idling (1)
b) Position the gear selector (3) according to the type of work and condition of the terrain.
c) Increase the engine speed to an average speed using the accelerator (1)
d) Press the clutch activation (2) and increase the engine speed until it is suitable for the work to be performed.
e) To change gear, repeat steps a, b, c and d.
HORIZONTAL ADJUSTMENT OF THE HANDLEBAR (4)
Allows lateral orientation of the handlebar; unlocking the handlebar is done by turning the cam (4) counterclockwise
and clockwise to lock it in the desired position.
MANUAL STARTING
COLD START:
Open the fuel supply.
Select the ON option on the switch (5)
Place the air intake in the closed position (right).
Move the throttle (1) 1/4 of its stroke counterclockwise.
Pull the manual starter gently until you feel resistance from the motor, from this point pull energetically until it is
running (repeat this operation if necessary).
When the engine is running, move the air intake to the open position (left).
HOT START:
Open the fuel supply.
Select the ON option on the switch (5)
Move the air inlet to the open position (left).
Pull the manual starter gently until you feel resistance from the motor, from this point pull energetically until it is
running (repeat this operation if necessary).
1
4
5
2
3

Publicidad

Tabla de contenido
loading

Tabla de contenido