Maintenance - Greencut GTC300X Manual De Instrucciones

ENGINE STOP
• Using the accelerator (1) bring the engine to the minimum number of revolutions.
• Select the OFF option on the switch (5).
• Close the fuel valve.
SECURITY DEVICE
To guarantee maximum safety of the operator, the machine is equipped with the following safety device:
-
Reverse gear cam control; when releasing the cam, the reverse gear is disconnected automatically.
ATTENTION: Do not use the machine if the safety device is not working properly for any reason to
avoid damaging the safety device

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
NOTE: During the first 50 hours of machine operation, do not perform excessively hard work.
NOTE: The frequency of cleaning of the air filter depends on the environmental conditions in which
the machine has been used, and it is recommended not to exceed 8 hours of work. The air filter
must be moistened with engine oil up to the line indicated on the air filter container.
MAINTENANCE
Check
Belt tension
Change
Check level
Engine oil
Change
Check
Air filter Clean
Replace
Check
Transmission
wheel
Replace
Wheel pressure Check
Shaft teeth Clean
Half-shaft of
Lubricate
the wheel
EVERY
EACH USE MONTH OR
24H USE
X
X
X
X
X
X
X
X
EVERY 6
EVERY 3
MONTHS
MONTHS
OR 100H
OR 50H USE
USE
X
X
X
X
79
EN
EVERY YEAR
OR 300H
USE
X