Step 8: Door Removal And Reinstallation - Thermador PROFESSIONAL PRO HARMONY PRG305PH Manual Del Usuario

2. Remove the (4) drill point screws securing the trim to
the side panels, and the (3) drill point screws securing
the piece to the back panel. Lift up to fully remove.
Figure 15: Zero Clearance Trim Rear Screw Removal
3. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range (Figure 16).
4. Make sure the backguard's front face is outside the
flange on the front side of the range.
5. Re-install screws removed in Steps 1 and 2.
Installation Instructions
Figure 16: Backguard Installation
Figure 17: Low Back Front View
STEP 8: Door Removal and
Adjustment
CAUTION
• USE CAUTION WHEN REMOVING THE DOOR.
THE DOOR IS VERY HEAVY.
• Make sure oven is cool and power to the oven has
been turned off before removing the door. Failure to
do so could result in electrical shock or burns.
• The oven door is heavy and fragile. Use both hands to
remove or replace the door.
• Failure to grasp the oven door firmly and properly
could result in personal injury and product damage.
• With the door off, never release the levers and try to
close the hinges. Without the weight of the door, the
powerful springs will snap the hinges closed with
great force.
To Remove the Oven Door
1. Be sure to read the above
CAUTION before attempting
to remove the door.
2. Open the door fully.
3. Flip hinge clip down. A
screwdriver may be required
to carefully pry the clip back.
4. Close the door gently until
it stops against the hinge clips.
The open hinge clips will hold
the door open at a slight angle,
about 30°, from the closed
position.
5. Grasp the door firmly
on the ends of the door.
Lift the door up and out.
There will be some spring
resistance to overcome.
6. Place the door in a
safe and stable location.
Figure 18: Door Removal
English | 18 |