Velleman SKY FIGHTER Manual Del Usuario página 5

7. Flying Your Drone
7.1 Synchronizing the Remote Control and Drone
1. If you have not done so, install the charged battery into your quadcopter. Also, install the batteries
in the remote control.
2. Place the drone on a flat and non-slippery surface.
3. Push and hold the throttle stick completely downwards.
4. Switch on your remote control by sliding the on-off switch to the on position. Synchronizing has
been completed when the power LED burns steadily.
If synchronizing has failed – if the power LED is still blinking – or if the
drone is beyond control, switch off both the drone and the remote
control, and start the synchronizing procedure again.
If the power LED blinks slowly, please recharge the drone's battery.
7.2 Flight Training
This drone is a fast-reacting aircraft, which requires only slight stick
movements to manoeuvre. Remember that crashing your drone can
cause injury, and damage the aircraft and surrounding objects beyond
repair.
It is therefore very important to first practice and clock up enough
"flying hours" to gradually increase your flying skills. Slowly lift the
drone and try to hover 50 to 60 cm above the ground. Land the drone
carefully.
The next step is to try and move your drone left/right and
forward/backward.
Repeat these exercises until you have mastered them.
7.3 Manoeuvring the Drone
Calibrating the Drone
Pull and hold the left cyclic stick to the lower left corner, pull and hold the right cyclic stick to the lower
right corner.
After 3 seconds, the LED on the drone will flash, meaning calibration is successful.
V. 01 – 15/05/2017
RCQC5
WARNING
REMARK
5 ©Velleman nv