DeWalt DWE4100 Manual De Instrucciones página 11

4-1/2" (114.3 mm) Grinding Wheels
Type 27 guard
backing flange
Type 27 depressed
center wheel
threaded clamp nut
ATTACHING SIDE HANDLE (FIG. 2)
The side handle (C) can be fitted to either side of
the gear case in the threaded holes, as shown.
Before using the tool, check that the handle is
tightened se cure ly. Use a wrench to firmly
tighten the side handle.
Type 27 guard
Type 27 hubbed wheel
Rotating the Gear Case
(Fig. 3)
FIG. 2
C
NOTE: If the gear case and motor housing become separated
by more than 1/8" (3.17 mm), the tool must be serviced and
re-assembled by a D
serviced may cause brush, motor and bearing failure.
9
Wire Wheels
Type 27 guard
3" (76.2 mm)
wire cup brush
1. Remove the four corner screws
attaching the gear case to motor
housing.
2. Without separating the gear case from
motor housing, rotate the gear case
head to desired position.
WALT service center. Failure to have the tool
E
3. Reinstall screws to attach the gear case to the motor housing.
Tighten screws to 18 in.-lbs. torque. Overtightening could cause
screws to strip.
Type 27 guard
4" (101.6 mm) wire wheel
FIG. 3
90˚
90˚