Publicidad
Idiomas disponibles
Idiomas disponibles
The operationof any
SAFETY
GLASSES
lawn mower can result
in foreign objects thrown
into the eyes, which can
result in severe eye dam-
age. Alwayswear safety glasses or
eye
shields while operating your lawn mower
or performing
any adjustments
or repairs.
We recommend
a standard safety glasses
or wide vision safety mask worn over
spectacles.
HOW TO USE YOUR LAWN MOWER
ENGINE
SPEED
The engine speed was set at the factory
for optimum performance.
Speed is not
adjustable.
ENGINE ZONE CONTROL
,ACAUTION:
Federal regulations
require
an engine control to be installed on this
lawn mower in order to minimize the
risk of blade contact injury. Do not under
any circumstances
attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO OPERATE
DRIVE SYSTEM
•
To start forward motion, lift drive con-
trol bar up to handle.
•
To stop forward motion, release drive
control bar.
IMPORTANT:
Always keep drive control
fully engaged against handle when in use.
Operator
presence
control bar
DRIVE CONTROLENGAGED
DRIVE CONTROLDISENGAGED
8
TO ADJUST
CUTTING
HEIGHT
Raise wheels for low cut and lower wheels
for high cut, adjust cutting height to suit
your requirements.
Medium position is
best for most lawns.
•
To change cutting height, squeeze ad-
juster lever toward wheel. Move wheel
up or down to suit your requirements.
Be
sure all wheels are in the same setting.
NOTE: Adjuster is properly positioned when
plate tab inserts into hole in lever. Also, 9-
position adjusters (if so equipped) allow lever
to be positioned between the plate tabs.
ROTATE LEVER TOWARD
ENGINE TO LOWER MOWER
Plate tab
-Lever
ROTATE LEVER AWAY FROM ENGINE
TO RAISE MOWER
TO CONVERT
MOWER
Your lawn mower was shipped ready to be
used as a mulcher.
To convert to bagging
or discharging:
REAR BAGGING
• Lift rear door of the lawn mower and
place the grass catcher frame hooks
onto the pivot brackets.
• To convert to mulching or discharging
operation,
remove grass catcher and
close rear door.
door
bracket
Grass
catcher
handle
Grass catcher
frame hook
SIDE DISCHARGING
• Rear door must be closed.
• Open mulcher door and install dis-
charge deflector under door as shown.
• Mower is now ready for discharging
operation.
• To convert to mulching or bagging
operation,
discharge deflector must be
removed and mulcher door must be
closed.
Publicidad
