Garland HARVEST 962 NRQG Manual Do Operador página 56

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
English
If the engine motor does not work properly (lack of power, unstable idling, etc.) below is a series of symptoms,
their probable cause and solutions.
Symptom
The machine beeps
The engine overheats
The engine does not turn
over
The engine stops or does not
maintain an idle state.
If the milling cutters do not move or work properly:
Problem
The milling cutters do not
turn
The milling cutters don't
Break into the earth
In the case of not being able to solve the problem, take your machine in for a service check. To locate the after-
sales service nearest to your location, please contact the point of sale where you purchased the machine.
Probably cause
Worn segments
Used piston
Crankshaft clearance
Slack in the clutch
Dirty exhaust pipe
Unsuitable fuel
Dirty carburetor
Dirty air filter
Dirty air filter
Poorly-adjusted carburetor
Poorly-adjusted carburetor
Probably cause
Extraneous matter in the milling cutters
Loose milling cutters. The milling
cutter's bolt is lost.
Incorrect clutch adjustment or Broken
cable
Internal transmission problem
Milling cutters incorrectly
placed, the edges are placed
in the wrong direction
56/180
Corrective action
Send your machine to the service technician
Send your machine to the service technician
Send your machine to the service technician
Send your machine to the service technician
Send your machine to the service technician
Replace the fuel
Send your machine to the service technician
Clean the filter
Clean the filter
Send your machine to the service technician
Send your machine to the service technician
Corrective action
Remove extraneous matter
Tightly place the bolt.
Send your machine to the service
technician
Send your machine to the service
technician
Send your machine to the service
technician

Publicidad

Tabla de contenido
loading

Tabla de contenido