Skoda AZA 700 001A Instrucciones De Montaje página 8

- Fasten the wire in such a way that it may not get frayed, and no noise may be produced
during vibrations.
- Connect the phantom adapter from the kit AZO 700 001 according to the instructions for
AZA 700 001A for the terminal board of the car radio T8d/PIN 5.
- Fit the anti-noise screen (B) upon the interconnecting cable harness (A), and connect the
harness with the harness of the electric installation of the vehicle.
GB
In this way, the electric installation for the fitting of an unoriginal car radio has been
prepared.
- Before connecting the car radio, check, or adapt the connection of the 8-pole (grey)
power supply terminal board – in particular, PIN 7 and PIN 4.
- From the manufacturing plant, the terminal board of the kit AZO 700 001 is connected
in the following way:
PIN 7 - +12 V (the so-called „30"),
PIN 4 - +12 V switched (the so-called „15" or „S-contact").
Caution: the connection of these PINs differs depending on the specific car radio!