Seenergy Flat 60 BL Instrucciones De Montaje página 12

Dear Customer,
thank you for choosing us!
Congratulations for having purchased your new
kitchen hood.
In order to use the appliance safely and to better know
all of its features and performances:
Read this instructions manual carefully before
•
installing and switching the appliance on.
Special attention shall be paid to safety warnings!
•
The appliance shall only be used according to
•
instructions given in this user manual.
Keep this instruction manual for further reference.
•
In case the appliance is given to third party, the
•
instructions manual shall also be given.
GENERAL INFORMATION
When exchanging information with the appliance
MANUFACTURER, please refer to the serial number
and identification data specified in the rating label.
This appliance has been designed, tested and
manufactured in full compliance with any relevant
standards on :
Safety: CEI/EN 60335-1; CEI/EN 60335-2-31;
•
Performance: CEI/EN 61591; CEI/EN 60704-1; CEI/EN
•
60704-2-13; EN 50564; CEI 62301.
EMC: EN 55014-1; EN 55014-2; CEI/EN 61000-3-2; CEI/
EN 61000-3-3.
Recommendations for proper use of the appliance
aimed at reducing environmental impact : when you
start cooking, switch the hood on at minimum speed
and switch it off only few minutes after you finished
cooking . Increase the hood speed only in case of large
amounts of vapours and fumes , and use the booster
function only when absolutely necessary. Clean the
grease filter only when necessary, in order to keep its
efficiency over time. Use a piping system having the
maximum diameter specified in this manual, in order
to increase efficiency and reduce noise levels.
The symbol on the appliance or on its
documentation indicates that this product
shall not be treated as household waste, but it
shall be handed over to a specific collection
point for the recycling of electrical and electronic
equipment. Proper disposal of this appliance will help
reduce raw materials consumption and environmental
pollution.
For more detailed information about recycling of this
appliance, please contact your local city office, your
household waste disposal service or the shop where
you purchased the appliance.
Spare Parts
Use original spare parts only.
Replace components before they are worn out.
Perform regular maintenance checks, as detailed in
the "MAINTENANCE " section.
Warranty
In order to enjoy the MANUFACTURER'S warranty,
users shall strictly follow all the instructions specified
in this manual, in particular they shall :
- use the hood only for its intended purposes;
- perform continuous and scrupulous maintenance
operations
- allow the use of the hood only to persons with
proven skills and know-how.
Failure to comply with the instructions contained in
this manual will immediately void the manufacturer's
warranty.
INSTALLATION INSTRUCTIONS
Installation and electrical connection operations
•
shall be performed
instructions and by qualified and specialized
personnel.
Wear protective gloves before and during
•
installation.
Check that no accessory material provided with
•
the appliance (manuals, accessories, etc) is placed
inside the hood: in such a case remove and keep
them.
Figures shown in this installation manual might
•
also refer to different aesthetics of the appliance:
in any case use, installation and maintenance
instructions remains the same.
SAFETY MINIMUM DISTANCE x (*)
The minimum installation distance between the
lowest part of the range hood and the hob shall be not
less than 550 mm from electric hobs and 650 mm
from gas hobs.
If minimum distances specified in the hob installation
manual are higher, then the appliance shall be
installed taking these greatest distances into account.
Wall installation:
To install the appliance, use expansion anchors and
screws which are suitable for your type of wall
(reinforced concrete, plasterboard, etc.)
- This wall-mounted hood can work both in the
SUCTIONING mode, with fumes exhausted outside
and the RECIRCULATION mode, with fumes internal
recycling.
RECIRCULATION mode
Caution! Charcoal filters shall be ordered at your
retailer's.
HOW THE HOOD WORKS
Touch Control
•
P0: Motor OFF key
st
P1: 1 speed key ("P1" symbol lights up)
P2: 2 rd speed key ("P2" symbol lights up)
rd
P3: 3 speed key ("P3" symbol lights up)
12
according to
(fig. 3 - 4)
(fig. 1 - 15 - 16)
(fig.17)
these