Model 750X; Aligning The Drill Bit - DRILL DOCTOR 750X Guia Del Usuario

2.
On the Model 750X
Point Angle
Adjustment Knob
the custom angle of your choice. Choose your point angle
based on the application you're drilling. Then re-tighten
the Knob.

Aligning the Drill Bit

This makes sure that the Drill Doctor creates the right
geometry. And, it sets the bit so that only a small amount
of the tip is taken off.
See page 17 to align and sharpen a Masonry drill bit.)
8
Point Angle
Adjustment Knob
Choose the angle
Loosen
Angle
Knob on the right side
of the Sharpening Port
and slide the metal
Point Angle Adjust-
ment Plate to either
the standard 118° or
the flatter 135° point
angle. Then re-tighten
the Knob.
Choose the angle
The Model 750X has addi-
tional advanced features that
enable you to fine-tune your
bit geometry. Loosen the
Point Angle
Knob to the right of the
Sharpening Port and slide the
metal Point Angle Adjust-
ment Plate to 118°, 135° or
www.drilldoctor.com
the Point
Adjustment
Adjustment