DRILL DOCTOR 750X Guia Del Usuario página 11

Ocultar thumbs Ver también para 750X:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.
2.
Alignment Button
118°
Drill Bit
Stop
start your alignment in the closest setting to the point
angle you are using. (For example, if you are setting the
point angle below 118°, than set the alignment in the 118°
setting.) Refer to "Using the Variable Alignment to Adjust
the Chisel and Relief Angle" on page 19.
www.drilldoctor.com
1"
Alignment
Guide
Insert bit in Chuck and
tighten
Insert the bit into the Chuck
Jaws and close the Jaws just to
the point where the bit slides in
and out. Do not over tighten
the Chuck; the bit needs to be
able to move in and out until
Step 4. (Model 750X users
refer to "Using the Variable
Material Take-Off (MTO)" on
page 20.)
A good test to see if the Chuck
is tightened the correct amount
is to make sure it moves when
you pull on it with your fingers,
but will not fall out when you
turn the Chuck upside down.
Insert Chuck into
Alignment Port
Press the Alignment
Button down and hold it.
Match the either of the
Alignment Guides on the
Chuck with the 118°
Notch on the Alignment
Port. Insert the Chuck.
While holding the button
down, slide the drill bit
forward until it touches
the Drill Stop and the
Chuck is pushed all the
way into the Alignment
Port. Release the Align-
ment Button.
If you are using a Model
750X and have chosen
a
custom
(between 115° and 140°),
bit
point
9

Publicidad

Tabla de contenido
loading

Productos relacionados para DRILL DOCTOR 750X

Este manual también es adecuado para:

500x24751

Tabla de contenido