Maintenance - KLASS Fan TORONTO DC Manual De Instrucciones

4 Blades Weight
Once you have measured the previous three points, switch on
your fan and check if it is vibrating.
If this is not the case, you have just finished installing your fan.
If you notice a vibration, proceed as follows:
Use the balancing kit, take the pliers from the kit.
On the first blade, at the end pinch the pliers and spin your fan.
If you notice that the fan does not vibrate, remove the pliers, use a 1 gram lead and
stick it at the end of the blade, on its upper side (facing the ceiling).
If the vibration continues, proceed for each blade in the same way until any
vibration disappears.
You have just installed your fan, enjoy it!

MAINTENANCE

- 10 days after the installation of your fan, check the screws of the blades, and all
the fixings of your fan.
- If necessary, screw the screws again. In case you notice that the fan attachment
has gotten loose, re install it.
- Clean your fan with a dry, non-abrasive cloth to prevent damaging the paint
- You should not oil the fan; the latter is equipped with a self- lubricating motor,
that uses a high specific viscosity oil.
- In case of any doubt, please contact your distributor
For these operations, make sure the power supply is off.
21