Craftsman 139.5399011 Manual Del Propietário página 5

Planning (Continued)
ONE-PIECE DOOR INSTALLATIONS
• Generally, a one-piece door does not require
reinforcement. If your door is lightweight, refer to
the information relating to sectional doors in
Installation Step 11.
• Depending on your door's construction, you may
need additional mounting hardware for the door
bracket (Step 11).
Without a properly working safety reversal system,
persons (particularly small children) could be
SERIOUSLYINJUREDor KILLED by a closing garage
door.
• The gap between the bottom of the garage door and
the floor MUST NOTexceed 1/4" (6 ram). Otherwise,
the safety reversal system may not work properly.
• The floor or the garage door MUST be repaired to
eliminate the gap.
ONE-PIECE DOOR WITHOUT TRACK
Header Wall
FINISHED CEILING
Support bracket
& fastening
hardware is required.
See page 16.
Rail
Slack in chain tension
is normal when garage
door is closed.
Motor Unit
Safety Reversing Sensor
J
Access
Door
Safety Reversing
Gap between floor Sensor
and bottom of door must not exceed 1/4" (6 ram).
Walt-mounted
Door Control
leader
Call
CLOSED POSITION
Trolley Stop Bolt Cable Trolley
Emergency
Release
Rope & Handle
lONE-PIECE DOOR WITH TRACK
Safety
Reversing Sensor
Access I
Door I
()1
Reversing
Gap between floor Sensor
and bottom of door
must not exceed 114" (6 mm).
CLOSED POSITION
Trolley Stop Bolt Cable
--Header C
Bracket DoorA
_D °°°
Door
Bracket Straight
Door
Garage Am
oor •
Chain
Rail
Emergency
Release
Rope &
Handle
5