Brizo MultiChoice Charlotte T60085 Instrucciones Para La Instalación página 6

60 Series Installation
Installation and Adjustment of the Temperature Knob
4
Failure to do so may cause injury.
1
5
6
Adjust temperature limit stop. Turn on water
supplies; let the water run at both full hot and
full cold to ensure the water is running as hot/
cold as possible. Place a thermometer in a
plastic tumbler, and hold the tumbler in the water
stream. Place the temperature knob (1) onto the
splines (2), then rotate the temperature knob
until you achieve your maximum desired
temperature from the outlet (not more than 120°
or the lower temperature mandated by your local
60 Series Maintenance
Faucet leaks from showerhead or tub spout:
SHUT OFF WATER SUPPLIES. Replace Cartridge
Assembly –Repair Kit RP47201.
2
4
plumbing code). Remove the temperature knob
and replace onto the splines (2), making sure that
the temperature knob limit stop (3) hits against
the volume handle limit stop (4) as shown.
Note: Temperature lever is intended to point
upward near 12 o'clock position. Once desired
position is acquired per instructions above, thread
screw (5) into handle (1) and secure it to valve
stem by tightening screw. Insert button (6) into
screw hole.
If water does not flow:
Verify that the hot side of the cartridge is installed
on the hot water supply line. If it is not, turn off
water supplies and flip cartridge.
6
1
4
3