RIDGID HD1614 Manual Del Usuario página 7

ASSEMBLY
Attaching Powerhead Assembly
to Dust Drum
1. Place Powerhead Assembly on top of
Dust Drum with the Extended Lip of the
Lid aligned with the Vac Inlet. Be sure
Powerhead Assembly is fully seated on
the Dust Drum.
Powerhead
Assembly
Extended
Lip
Vac
Inlet
Dust
Drum
2. Press in on the two Latches located
on either side of the Dust Drum until
they snap into place, securing the
Powerhead Assembly to the Dust Drum.
3. To remove the Powerhead Assembly,
pull out on the two Latches and lift
Powerhead Assembly from the Dust
Drum. Do not force the Latches to
rotate more than slightly outside Drum
flange.
Powerhead
Assembly
Drum
Latches
(1 on each
side)
Dust
Drum
Carry Handle Assembly
1. Locate the Carry Handle and the two
(2) #10 x 3/4" (19 mm) Pan Head
Screws in loose parts bag.
2. Position the Carry Handle on top of the
Powerhead Assembly, with the Carry
Handle Extended Flange to the rear of
the Powerhead Assembly, as shown.
3. Insert a #10 x 3/4" (19 mm) Pan Head
Screw through the hole at each end of
the Carry Handle and into the Powerhead
Assembly. Tighten securely.
#10 x 3/4"
(19 mm) Pan
Head Screws (2)
Extended
Flange
Powerhead
Assembly
7