BQS BL123 Manual De Uso página 12

4. Place your knee on the seat of the child seat and hold the
diagonal shoulder belt. Pull it upwards to tighten it as much as
possible (3.7).
5. Finish tightening the vehicle seat belt by pulling the diagonal
shoulder belt upwards until there is no slack and the child seat is
securely installed (3.8).
When the seat is being used for group 1, the belt should go under
the headrest and this should be in its lowest position.
Ensure that the belt has no slack.
4. HOW TO INSTALL THE CHILD CAR SAFETY SEAT. GROUP 2 & 3.
WARNING
Before installing the seat it is necessary to remove harness straps,
crotch straps and lap straps as shown in Chapter 6.
1. According to the child's height the headrest can be adjusted up or
down. Place your hand on the headrest and press the lever while
pulling the seat down with the other hand so it does not move
(4.1).
2. Place the child seat on the seat of the vehicle, ensuring it is
pressed firmly against the back of the vehicle seat (4.2).
3. Place the child in the child car safety seat(4.3).
4. You will hear a "click" when this is properly fastened. Ensure
that the belts are not twisted and tighten by pulling the diagonal
shoulder belt upwards (4.4, 4.5 y 4.6).
It is advisable to continue using the seat backrest until the child's
height exceeds the headboard.
Child restraint system
22
Use Group 2 & 3 only from approx.
4 to 12 years of age (15-36 kg)
5. ADJUST THE HARNESS TO THE HEIGHT OF THE CHILD.
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below
the back slots at a suitable height (5.1).
Changing the harness height
1. Adjust the height of the harness, by pressing the harness
adjustment button and pulling the harness straps towards you to
loosen them (5.2).
2. Then unhook one of the harness connector straps
of the seat and pull the loose strap towards the front of the seat
(5.3, 5.4 y 5.5).
3. Insert the harness strap into the
at the front of the seat. Then insert the harness strap into the
appropriate upper or lower slot at the rear of the seat (5.6).
4. Reinsert the harness strap in the harness connector
back of the seat (5.7).
5. Then, do the same with the other harness strap. Verify that the 2
harness straps go through the slots at the same height.
Fastening the harness
1. Join the 2 buckle metal connectors (5.8).
2. Pass both connectors through the slot in the upper part of the
buckle until you hear a "click" (5.9).
3. Always make sure the harness is properly fastened by pulling the
harness straps upwards.
4. To unfasten the harness press the red button on the buckle
downwards (5.10).
Tightening the harness
1. Pull the harness straps up to remove the slack from the lap
section of the harness, then pull the harness regulating strap until
the harness is fully stretched (5.11).
BL123 Group 1/2/3
O at the back
N slot of the fabric and backrest
O on the
www.babyqs.com
EN
23