Klarstein VINSIDER 35D Manual De Instrucciones página 29

1. Close the glass door, and remove the deco- ration plug 2. Unscrew the top hinge
pin 3 and lower hinge pin 8. Be careful to support the glass door with hands to
prevent it drop- ping after removing the pins. (Figure 1&2).
2. Pull down to remove the glass door and place it on a padded surface to prevent
scratching it.
3. Remove the right top hinge plate 4 by un- screwing the four screws 1 and get the
left top hinge plate 6 from the plastic bag that includes the instruction manual then
install it at the designated position on the opposite side. (Figure 1)
4. Remove the lower hinge plate 7 by unscrewing the four screws 9. Then turn it
around and refit it on the opposite side. (Figure 2)
5. Turn around the glass door 180° and refit the hinge pin 3&8 through the top hinge
plate 6 and lower hinge plate 7 into the door. Make sure that the spacers which the
hinge pins sit on are correctly positioned.
6. Leveling the door by adjusting the screws that are used to fix the top hinge plate
and lower hinge plate.
EN
29