WET Style BC 0102 Guia De Instalacion página 11

Installation guide
Place the bathtub within the frame so that its rims are properly
5
seated on the rame. Once the tub is in place, make sure the
levelers are properly sitting on the floor, so that the tub's entire
weight does not rest on the rims . This could damage your
bathtub.
Note: Use a level to ensure accuracy.
IMPORTANT: BC 05, and BC 09
6
A mounting bracket must be installed with these modeles.
Attach the bracket horizontally to the existing structure at
the requisite height. Install on all sides of the tub that are
!
against a wall.
1. Deck of tub.
2. Deck reinforcement, use 3/4" plywood or 2x3 stud; not supplied.
3. Existing vertical structure.
ATTENTION: To keep the back ledge from bending and prevent water
accumulation, it is essential to install such a bracket.
Tile Flange: Place the bathtub so that the tile
7
flange rests against the existing wall structure.
Install the gypsum plasterboard or cement panels
so they just the tile flange.
Connect the bathtub drain to the floor drain. Hook up the water to the faucet. Check that all
8
connections are waterproof.
Do a silicone joint pressure seal between the bathtub and the finished surfaces.
9
8
Montréal - Canada | 1-888-536-9001 | www.wetstyle.com | November 2019
3
1. Deck of tub.
2. Podium partitions.
2
3. Ceramic.
cross section
1. Deck of tub
2. Existing vertical structure
3. Gypsum plasterboard panel
4. Tile flkange
5. Finishing
6. Pressure seal
9
1 1
3
2
1
2
3
5
3
4
6
2
1
P. 11