KOBE BRILLIA INX-026 Serie Instrucciones De Instalación Y Manual De Operación página 11

APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES.
BEFORE CONNECTING WIRES, SWITCH POWER OFF AT
SERVICE PANEL AND LOCK SERVICE PANEL TO PREVENT
POWER FROM BEING SWITCHED ON ACCIDENTALLY.
14. Connect electrical wires.
15. Connect three wires (black, white and green) to house wires
and cap with wire connectors. Connect wires corresponding
to their colors (i.e. black to black, white to white, and green
to green).
16. Store wires in a wiring box.
Hood Installation
NOTE: USE HAND TOOLS ONLY. DO NOT OVER TIGHTEN
SCREWS, MAY CAUSE DAMAGE TO THE HOOD.
17. Remove the light panel by removing 10 screws located at the
bottom of the hood (Refer to Figure 11). Carefully remove the
light support panel.
18. Position the hood inside the custom wood frame, and secure
the hood to the front and rear stud support ( Refer to Figure 2)
by using the front and rear mounting holes (Screws not
included).
19. For a more secure installation, use the mounting holes
located on the side of the hood
20. Make sure hood is secure before releasing.
21. Re-install the light support panel.
screws.)
CAUTION
: MAKE SURE HOOD IS SECURE BEFORE
RELEASING
(Do not over tighten
7
Figure 9
Figure 10
Figure 11