Blade Installation - LUCCI BORDONO Serie Manual De Instalación, Operación, Mantenimiento

Installing the down rod
The down rod has been pre-assembled.
Lift fan assembly onto mounting bracket.Fig.5
Ensure the notch of the ball joint is
positioned on the stopper of mounting
bracket to prevent fan from rotating when in
operation.
Blade attachment
1. Insert the blades through the side slot of motor and align with the
3 holes.
2. Secure the blades with 3 blade screws, and ensure that the 3
blade screws are tightened evenly. Do not over tighten the
screws as this can damage the blades. Repeat this process for
all blades. Fig 5.
1. Remove the 3 light kit screws (2, Fig.5) from light base.
2. Insert the pull chain (3, Fig.6) through the holes of light kit (4, Fig.6).
3. Connect the fan and light pendant (5) to pull chain.
4. Connect the quick connector (2, Fig.6), and then push them into the switch housing (1, Fig.6).
5. Attached the light kit to light base and align the screw holes, then secure light kit with 3 light kit
screws.
6. Install the globe.
HANGING THE FAN
INSTALLING THE FAN
Fig. 4

BLADE INSTALLATION

LIGHT KIT INSTALLATION
INSTALLING THE FAN
6
Fig.5