Publicidad
Idiomas disponibles
Idiomas disponibles
TO ASSEMBLE
THE HANDLE
AND
CRANK
ASSEMBLY
1. Cut tie holding shift rod to lower
handle and move shifter to the first
forward gear.
2. Cut and discard the plastic tie that
secures the crank assembly.
3. Loosen, but do not remove, the
screws, flatwashers, Iockwashers,
and hex nuts in the upper holes of
the lower handle.
See Figure 3.
4. Remove the fasteners and the eye-
bolt from the lower holes of the low-
er handle See Figure 5.
Right Hand Side
Of Upper
Loosen,
but do not
remove
11/32"
Flatwasher
5/1 6"
Screw
Figure 3
NOTE:
Make sure the cables are not
caught between the upper and lower
handle.
5. Raise the upper handle into operat-
ing position.
NOTE:
If the cables have become dis-
connected form the clutch levers, rein-
stall the cables as shown in Figure 4.
Clutch Lever
"Z" Fitting
Control
Cable _,
6.
Install the fasteners
that were re-
moved
in step 4. DO NOT tighten
until all bolts are in place.
Left Side Of _.\
Upper Handle --4,
Crank
Eye Bolt
f
3/8" Nylon
Locknut
j!i!
\
Flatwasher
Figure 5
7. Attach the crank rod to the universal
joint assembly with the hair pin. See
Figure 6.
8. Tighten nut on eye bolt, Make sure
eye bolt is properly aligned and the
crank can freely rotate.
9. Tighten all handle and panel bolts.
Universal Joint Asser
d
Crank qod
Figure 6
Figure 4
F 0410109L
8
Publicidad
