Assembly Instructions - GIESSE TUBE-LOCK Manual De Uso E Instalación

Stroke 18 mm. The key of the dip-switch should be moved to the ON position towards the power supply
cable.
Stroke 36 mm. The key of the dip-switch should be moved to the OFF position opposite the power supply
cable.

The factory settings are the following: dip1 = ON, dip2 = OFF.

8. ASSEMBLY INSTRUCTIONS

These instructions are intended for technical and specialized personnel, therefore basic
All operations for preparation, assembly and electrical connection must be carried out by technical
and specialized personnel; this will guarantee optimum performance and proper operation of the
electromechanical lock.
First check that these fundamental conditions are met:
The performance of the electromechanical lock must be sufficient to move the sliding accessory
without any obstruction whatsoever; the limits specified in the product's technical data table (page
5) must not be exceeded.
Check that the electric power supply used corresponds to that specified on the "technical data" label
attached to the machine and provided in the previous chapter.
Check that the electromechanical lock has not been damaged during transport, first by visual
inspection and then by powering it in one direction and the other.
Once the lock is installed, check that the latching hook of the pawl of the sliding accessory is
completely latched when the lock is closed and that after opening it's completely unlatched so as
to allow the window or door to open without any obstruction.
8.1.1.
If you want to position the cable exit on the opposite side to the way it is supplied, proceed
as shown in figure B.
safety and working techniques are not discussed.
Power cable positioning: The product is supplied as shown in figure A.
24