Power Supply Cord Connection - Kenmore W10850306A Instrucciones De Instalación

POWER SUPPLY CORD CONNECTION

Power Supply Cord Strain Relief
1.
Attach power supply cord strain relief
Remove the screws from a 3/4" (19 mm) UL listed strain relief
(UL marking on strain relief). Put the tabs of the two clamp
sections (C) into the hole below the terminal block opening
(B) so that one tab is pointing up (A) and the other is pointing
down (D), and hold in place. Tighten strain relief screws just
enough to hold the two clamp sections (C) together.
2.
Attach power supply cord to strain relief
Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the strain
relief. The strain relief should have a tight fi t with the dryer
cabinet and be in a horizontal position. Do not further tighten
strain relief screws at this point.
If your outlet looks like this:
4-wire Power Supply Cord Connection
A
IMPORTANT: A 4-wire connection is required for mobile homes
B
C and where local codes do not permit the use of 3-wire connections.
D
4-wire receptacle (NEMA
type 14-30R)
Spade terminals with
upturned ends
Power supply cord 4-wire receptacle
(NEMA Type 14-30R):
Go to "4-wire Power Supply Cord
Connection".
Power supply cord 3-wire receptacle
(NEMA Type 10-30R):
Go to "3-wire Power Supply Cord
Connection".
4-prong plug
Ring terminals
11