Flow Check (Duct Condition Test) - LG STEAM DRYER DLEX0001TM Guía Del Usuario E Instrucciones De Instalacion

I N S TA L L AT I O N I N S T R U C T I O N S I N S TA L L AT I O N I N S T R U C T I O N S

FLOW CHECK (DUCT CONDITION TEST)

Your dryer features FlowSense
blockages and restrictions in dryer ductwork. Keeping ductwork clean of lint buildup and
free of restrictions allows clothes to dry faster and reduces energy use.
NOTE: When the dryer is fi rst installed, this test should be performed to alert you to any
existing problems with the exhaust duct in your home. However, since the test performed
during normal operation provides more accurate information on the condition of the
exhaust duct than does the installation test, the number of bars displayed during the two
tests may not be the same.
To activate the fl ow check (Duct condition test) :
NOTE: Dryer heating test must be performed before proceeding. Then perform the duct
condition test below:
After pressing the POWER ON/OFF, turn the cycle
1
knob.
When pressing the OPTION button, OFF will be
2
displayed.
OPTION
*LANGUAGE
When pressing CUSTOM PGM, OFF will be
3
change to ON.
CUSTOM PGM
*PGM SAVE
After 3 seconds, or
4
by pressing the EXIT
button, the display
will show the FLOW
CHECK start screen.
5
COMPLETED FLOW CHECK
THE DUCTWORK IS FREE
FROM BLOCKAGES OR
RESTRICTIONS.
NEED FLOW CHECK
THE DUCTWORK HAS
A BLOCKAGE THAT NEEDS
TO BE REMOVED
IMMEDIATELY.
IMPORTANT: Do NOT interrupt the test cycle!
24
™
, an innovative sensing system that automatically detects
ON I
FLOW CHECK
FLOW CHECK
THIS TEST CHECKS THE CONDITION
OF THE EXHAUST DUCT AT THE TIME
OF INSTALLATION
Press START/PAUSE. The dryer
will run for approximately 2
minutes to test
for blockages
or restrictions
FLOW CHECK
to air fl ow in the
ductwork.
If no bars are shown in
the display, the ductwork
is free from blockages
or restrictions.
If all bars are lit, the
dryer ductwork has a
blockage that needs to
be removed immediately.
Correct Venting
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows
or bends.
EST. TIME 0:02
REMAINING
Check for blockages and lint buildup.
HIGH
0:02
EST. TIME
REMAINING
HIGH
Make sure the ductwork is not crushed
or restricted.