Installation Test (Duct Check) - LG DLEY1201 Serie Manual De Propietario

Ocultar thumbs Ver también para DLEY1201 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

28
iNSTALLATiON iNSTruCTiONS

Installation test (Duct check)

Once you have completed the installation of the dryer, use this
test to make sure the condition of the exhaust system is adequate
for proper operation of the dryer. This test should be performed
to alert you to any serious problems in the exhaust system of your
home.
• Your dryer features FLOW SENSE
that automatically detects blockages and restrictions in dryer
ductwork. Keeping ductwork clean of lint buildup and free of
restrictions allows clothes to dry faster and reduces energy use.
NOTE
The dryer should be cool before starting this test. If the dryer
was warmed up during installation, run the AIR DRY cycle for a
F
few minutes to reduce the interior temperature.
To activate the installation test:
1. Remove the literature, and then close the door.
Do not load anything in the drum for this test, as in may affect
the accuracy of the results.
B
G
D
2. Press and hold the TEMP. CONTROL and OPTION buttons
and then press the POWER button.
This button sequence activates the installation test. The code
will display if the activation is successful.
3. Press START/PAUSE button.
The dryer will start the test, which will last about two minutes.
The heat will be turned on and the temperatures in the drum
will be measured.
TM
, an innovative sensing system
E
A
H
C
F
4. Check the display for results.
During the three minute test cycle, monitor the FLOW
SENSE
display on the control panel. If no bars are displayed,
TM
when the cycle ends, the exhaust system is adequate. If the
exhaust system is severely restricted, the display will show four
bars. Other problems may also be shown with error codes.
Refer to the next page for error code details and solutions.
NO BARS:
G
D
OK
Four bars indicates that the exhaust system is severely restricted.
Have the system checked immediately, as performance will be
poor.
5. End of cycle.
At the end of the test cycle,
will end and the dryer will shut off automatically after a short
delay.
A
H
FOUR BARS:
B
C
RESTRICTED
will display. The test cycle

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Dlgy1202 serie

Tabla de contenido