Error Code - GYS GYSPOT ARCPULL 350 Manual Del Usuario

• Put the pad (equipped with its cover) at the end of the earth rods and
screw in the 2 clamping screws. It is recommended to place the pad
with the clamping screws pointing down to the bottom of the gun to
keep the positioning markings clearly visible.
Note: The use of the gas protective pad and earth rods is not necessary
when welding a pull ring.
USE OF THE RIVET EXTRACTION SET (ref : 064584 and clamp ref : 043787)
• Completely remove the stop screw from the dowel pin holder and
insert the dowel into the gas protection nozzle.
• Place the earth rods (supplied with the product) and adjust their
positions.
• Mount and screw the gas protection barrel on the pad.
• Mount and screw the pad thus equipped onto the rods.
• Connect the positive gun cable (red marking) to the texas
negative (-) of the generator.
• Connect the ground clamp to the positive (+) texas of the generator.
ERROR MESSAGE, ANOMALIES, CAUSES, SOLUTIONS
This device integrates a default management system. In the event of a default, error messages may be displayed.

Error code

Generator thermal
OVERHEATI NG DEFECT
OVERVOLTAGE DEFECT
PRESSED KEY
GYSPOT ARCPULL 350
Meaning
Maximum duty cycle
protection
Mains power is out of
Mains voltage
range or one phase is
default.
A key on the keypad is
Keypad fault pushed when the machine
Screw
removed
Causes
Wait for the indicator to turn off before
reached.
ked by a qualified person. The voltage
between the phases must be between
missing.
Ask a qualified person to check the key-
is switched on.
Positioning
marking
Clamping screw
Gas shielding gun locknut
Stems
Solutions
resuming welding operations.
Have your electrical installation chec-
208V AC and 240V AC.
pad.
EN
Stud door
support
29