CONTROL LOCK FEATURE
control will resume the display of the room humidity. The humidifier will continue
to function with the locked in settings. If buttons are operated while "CL" is
active, the "CL" is displayed and settings are unaffected.
DEACTIVATION PROCEDURE
To deactivate the "CL" function simply press and hold the power button for 5
seconds. "CL" will flash at the rate of 1 second on and 1 second off for a period
of 2 seconds and then resume the display of room humidity.
FILTER REPLACEMENT AND CARE
Replace the evaporative wicking filter at least once per humidification season or
more depending on water conditions in your area. We also recommend using
bacteriostat to maintain the filter and unit's effectiveness.
1) Unplug humidifier. Before removing the
filter, we recommend moving the humidifier
to an area where floor coverings are not
susceptible to water damage. (i.e. kitchen
or bath areas.)
2) Remove the water bottle and set aside. Be
sure not to bump or damage the fill valve.
3) Grasp the housing assembly and lift
straight up and away from the base and set
aside. The filter is now accessible.
4) Take note of the filter position. Remove the
filter. You may want to clean the base at
this time. See the "Cleaning and
Maintenance" section of this manual.
5) Install a new filter, MAF1(CN), into the base. Coil the filter and position
it between the uprights in the bottom of the base. The start and finish
of the coil should be captured at the center of the base (see illustration
below) and the filter should be resting on the floor of the base.
To avoid unwanted tampering with the humidifier settings the
controls can be locked.
ACTIVATION PROCEDURE
After the humidifier functions have been set up, hold the
power button down for 5 seconds. The display will show
"CL" for 2 seconds; release the power button and the
6) Return the housing
assembly to the top of the
base. Reposition the
humidifier to its operating
position. The humidifier is
now ready to be filled for
operation
8