Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
Figure 1
Fasteners
typical
Conical washer
both sides
teeth side
against hitch
1.
Lower vehicle exhaust - Using an exhaust hanger removal tool, lower muffler by removing rearmost driver side rubber hanger and rearmost passenger side rubber hanger. NOTE: Be sure that
exhaust is supported before removing rubber hangers. A spray lubricant or soapy water on rubber hangers makes them slide off metal pins more easily.
2.
Install hitch – Using the supplied pullwires
into position and align holes in hitch bracket to the carriage bolts installed, guiding the pullwire ends through holes in the hitch bracket. Remove pullwires, install conical washers
m
side toward hitch) and nuts
, see Figure 1.
3.
Tighten all 7/16 - 14 Gr 5 " fasteners with torque wrench to 50 Ft.Lb. (68 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
4.
Reinstall exhaust – Raise exhaust back into position.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be
removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices
and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2020 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 36110, 06195, CQT36110
Frame rail
①②
Access Hole
lm
Authorized Drawbar Kit:
36051
(Sold Separately)
Drawbar must be used in the
RISE position only.
n
install the carriage bolts ①and spacers ② into the vehicle frame through the access hole, see Fig. 2, leave pullwires attached. Raise the hitch
⑤
Kink pullwire to keep spacer independent of bolt
Figure 2
Sheet 3 of 18
36110NP
Fastener Kit: 36110F
①
Qty. (4)
Carriage Bolt
7/16-14 x 1 1/2 " GR5
②
Qty. (4)
Spacer 3/16 "x 1"x 2"
Part #: 3837
l
Qty. (4)
Conical washer 7/16"
Part #: 01292007
m
Qty. (4)
Hex nut
7/16'', GR2
n
Qty. (4)
Pullwire 7/16''– 14
Part #: 5481
l
(teeth
3-4-20
Rev. B
Publicidad
