MCZ MASTER 4 Instrucción De Montaje página 19

ASSEMBLY INSTRUCTIONS
Before proceeding with assembly, remove all the parts from the box and make sure that no
components are missing. If, despite our strict quality controls, any components are missing,
please do not hesitate to contact our customer services offi ce. We will provide you with immediate
assistance.
You will need an adjustable spanner, pliers and a cross screwdriver for assembly.
Please read the assembly instructions carefully before starting. The product is not diffi cult to
assemble.
Assemble all the nuts and bolts, leaving them loose. Only tighten all the joints after completing
assembly. This facilitates assembly and increases the stability of the product.
PREPARATION
The barbecue operates with liquid gas cylinders (butane/propane) weighing from 3 to 5 kg. The
rubber gas tube and the calibrated regulator can be purchased from your nearest gas product
retailer.
IMPORTANT: only use reducers calibrated to the pressure established by current regulations in
the country where the barbecue is to be used. Refer to the table provided on the barbecue itself. It
is strictly prohibited to use adjustable pressure reducers.
INSTALLATION
Make sure that the reducer seal is still present and is not damaged. Change the seal every time you
replace the gas cylinder.
Screw the pressure reducer onto the cylinder, turning it in an anticlockwise direction. Tighten it
hermetically.
The case tube should be connected to the pressure reducer outlet connection as described below:
The other end of the gas tube should be secured fi rmly to the barbecue. It should be directly
engaged and secured by means of a specifi c metal clamp, or screw the gas tube connection onto
the barbecue connection. Place the cylinder to the side of the barbecue, not beneath it, making sure
that you keep it away from sources of heat and place it in a safe position.
Gas leak test:
During the gas leak test, remove all infl ammable sources from the surrounding area and avoid all
actions that could cause fi res.
Do not smoke!
Never carry out gas leak tests when the burner is lit!
Always perform the test outdoors.
The gas tube should be connected to the reducer and secured by means
of a specifi c metal clamp. Tighten it hermetically. Or
Screw the outlet connector onto the pressure reducer in a clockwise di-
rection, connect the gas tube to the connection and secure it by means
of a specifi c metal clamp. Tighten it hermetically. Or
Screw the gas tube connection in in an anticlockwise direction.
Tighten it hermetically.
19